Australia version. Metric by default with 10.05 m rolls in 53 cm and 52 cm widths, feature walls and 2.7 m ceilings, A$ prices and asbestos advice for walls in older homes. US version
Wallpaper Calculator (Australia)
Count wallpaper rolls for a feature wall or room in metres from the roll size, pattern repeat and match, with drops per roll, spare rolls and the cost in dollars.
The interactive tool loads here when JavaScript runs.
About this toolWhat is the Wallpaper Calculator?
In Australia wallpaper is most often hung on a single feature wall, so this version starts with the wall width rather than the whole room. A 3.6 metre feature wall needs 7 drops of a standard 53 cm roll. With 2.7 metre ceilings and a 64 cm half-drop pattern each drop is cut at 3.52 metres, a roll gives only two, and you need 4 rolls.
The same wall with a straight-match paper on the same repeat needs 3 rolls, and with 2.4 metre ceilings the half-drop paper also fits three drops to a roll. Ceiling height and match type together decide the order, which is why the calculator counts drops rather than dividing area by roll size.
Most rolls sold here are the 10.05 metre European size in 52 or 53 cm widths; wide rolls and mural panels come in other sizes, which the custom roll setting handles.
- Strip method with straight, half-drop and free matches
- Euro, wide and US double roll presets plus custom sizes
- Cut length, strips per roll and waste per strip shown
- Spare rolls and cost per roll
- Imperial and metric, runs in the browser with a share link
Updated
How to use the Wallpaper Calculator
- Choose total wall width for a feature wall, or room for all four walls.
- Measure the height from the top of the skirting to the cornice at both ends of the wall.
- Enter the width of doors and full-height openings only.
- Pick the roll width from the label and copy the pattern repeat and match.
- Add a spare roll from the same batch number and the price per roll in dollars.
Worked examples
Feature wall with 2.7 m ceilings
Input
Wall 3.6 m wide, 2.7 m high, 53 cm rolls, 64 cm half-drop repeat, 10 cm trim
Output
7 drops cut at 3.52 m; 2 per roll; 4 rolls
The half-drop adds 32 cm to every drop. Each roll then has about 3 m left over, which is useful for a short wall above a bedhead but not for another full drop.
Same wall, straight match
Input
Wall 3.6 m wide, 2.7 m high, 53 cm rolls, 64 cm straight repeat
Output
7 drops cut at 3.20 m; 3 per roll; 3 rolls
One roll less than the half-drop design, which is worth knowing when two papers cost the same per roll.
Whole bedroom, plain paper
Input
4 m x 3.6 m room, 2.4 m high, door and robe openings 2.62 m wide, free match
Output
24 drops of 2.5 m; 4 per roll; 6 rolls
With a 53 cm straight repeat the same room needs 8 rolls, because only three 2.65 m drops come from each roll.
Background and insight
The standard European roll is 10.05 metres long and 0.53 metres wide, about 5.3 square metres, the size most papers sold in Europe and the UK are made to. American papers are usually priced per single roll but sold as double rolls, and the common 20.5 inch by 33 foot double roll covers about 56 square feet before waste. Always check the label: widths of 0.52, 0.68 and 0.70 metres and 27 inch American rolls are common too.
Pattern repeat is the vertical distance before the design repeats. With a straight match every strip starts at the same point of the pattern, so each cut is the wall height plus trim, rounded up to whole repeats. With a half-drop match alternate strips are offset by half a repeat, which on average costs half a repeat more per strip. A free or random match, such as a texture or stripe, has no repeat to honour and wastes the least.
This is why large repeats are expensive. On an 8 foot wall with a 21 inch repeat each cut is 105 inches, so a 33 foot double roll gives three strips and 81 inches of offcut. The same roll with no repeat gives three strips of 100 inches; a 2.5 metre cut from a Euro roll gives four strips with a free match but only three with a 53 cm repeat.
Common use cases
Whole rooms
Order the right number of rolls from one batch before the first strip goes up.
Feature walls
Price a single wall in a bold pattern, where the repeat often decides the roll count.
Comparing papers
See how a large-repeat design changes the cost against a plain one at the same roll price.
Murals and custom rolls
Enter any roll width and length for papers sold off the bolt.
Tips and limitations
- If your home was built or renovated before 1990, walls and ceilings might contain asbestos sheeting. Do not sand or drill suspect panels before papering.
- Seal new plasterboard before papering so the paper can be stripped later without damaging the board.
- Buy all rolls with the same batch number and keep a spare for repairs.
- Painted walls with lead paint, common in houses built before 1970, need care before sanding to prepare a surface.
Sources and further reading
- Householders and home renovators, Asbestos and Silica Safety and Eradication Agency. Homes built or renovated before 1990 might contain asbestos.
- Lead Alert: The six step guide to painting your home (5th edition), Australian Government. Preparing painted surfaces in homes built before 1970.
- Wallpaper frequently asked questions, Graham and Brown. Pattern repeat and straight, half-drop and free matches.
Frequently asked questions
How many rolls of wallpaper do I need for a feature wall?
A 3.6 metre wall with 2.4 metre ceilings needs 2 rolls of plain paper or 3 with a large pattern. With 2.7 metre ceilings and a 64 cm half-drop it can be 4. Enter your wall and the repeat to see the count.
What size is a roll of wallpaper in Australia?
Most are 10.05 metres long and 52 or 53 cm wide, the European standard, covering about 5.3 m². Wider rolls and mural panels are sold in other sizes, so read the label.
Do high ceilings use more wallpaper?
Yes, and in steps. Four 2.5 metre drops fit on a 10.05 metre roll, but at 2.7 metres only three plain drops fit, and with a large pattern repeat it can drop to two.
Can I wallpaper over plasterboard?
Yes, once the board is sealed. A sealer stops the paste soaking in and lets you strip the paper later without tearing the plasterboard face.
Should I worry about asbestos before stripping walls?
If the home was built or renovated before 1990 it might contain asbestos. Do not sand, cut or drill wall sheeting you are unsure about; have it checked by a licensed assessor.
Is there an in-depth guide to the Wallpaper Calculator?
Yes. “How Many Rolls of Wallpaper? The Strip Method Explained” covers the background, how it works, common pitfalls and worked examples. Read the full guide.
Related Tools You May Like
Free, in-browser tools that pair well with this one.